Arduino motor drive and speed measurement with Labview (may need to improve)

 

Arduino Program:

const int ctrlPin1=7;
const int ctrlPin2=8;
const int enablePin=9;
const int directionSwitchPin=4;
const int onOffSwitchPin=5;
const int potPin=A0;

#define encoder0PinA 2
#define encoder0PinB 3
volatile unsigned long duration, CapTime, LastCapTime;

double Freq;
double rpm;
unsigned long now;
int onOffSwitchState=0;
int prevOnOffSwitchState=0;
int directionSwitchState=0;
int prevDirectionSwitchState=0;

int motorEnabled=0;
int motorSpeed=0;
int motorDirection=1;

void setup(){
Serial.begin(9600);

pinMode(encoder0PinA, INPUT);
pinMode(encoder0PinB, INPUT);

attachInterrupt(0, doEncoder, RISING);

pinMode(directionSwitchPin, INPUT);
pinMode(onOffSwitchPin, INPUT);
pinMode(ctrlPin1, OUTPUT);
pinMode(ctrlPin2, OUTPUT);
pinMode(enablePin, OUTPUT);

digitalWrite(enablePin, LOW);

}

void doEncoder(){
LastCapTime = CapTime;
CapTime = millis();
}

void loop(){

now = millis();
duration = CapTime – LastCapTime;
LastCapTime = CapTime;

if (duration==0){
Freq=0;
}else{
Freq = 1000/(double)duration;
}
rpm = Freq*60/2;
Serial.print(“time: “);
Serial.print(now);
Serial.print (” , speed = “);
Serial.println (rpm);

onOffSwitchState=digitalRead(onOffSwitchPin);
delay(1);
directionSwitchState=digitalRead(directionSwitchPin);
delay(1);

motorSpeed=analogRead(potPin)/4;

if(onOffSwitchState != prevOnOffSwitchState){
if(onOffSwitchState == HIGH){
motorEnabled = !motorEnabled;
}
}

if(directionSwitchState != prevDirectionSwitchState){
if(directionSwitchState == HIGH){
motorDirection = !motorDirection;
}
}

if (motorDirection == 1){
digitalWrite(ctrlPin1, HIGH);
digitalWrite(ctrlPin2, LOW);
}
else {
digitalWrite(ctrlPin1, LOW);
digitalWrite(ctrlPin2, HIGH);
}

if (motorEnabled == 1){
analogWrite(enablePin, motorSpeed);
}
else {
analogWrite(enablePin, 0);
}

prevDirectionSwitchState=directionSwitchState;
prevOnOffSwitchState=onOffSwitchState;

delay(250);

}

Labview Block Diagram (May need to improve) To drive with Labview: